Hope X2 Brake Pads

Hope X2 Brake Pads

Hope X2 2-Piston Disc Brake Pads are dyno-tested in-house in Barnoldswick, UK.

Sintered Pads high-graphite compound; best for wet-weather durability
Hope Part Number: HBSP237S

Organic Pads softer compound than sintered, works better in dry conditions, but wears faster
Hope Part Number: HBSP237

Other Hope Brake Pads

Hope V4 Brake Pads
Sintered: HBSP303S
Organic : HBSP303

Hope E4 Brake Pads
Sintered: HBSP323S
Organic: HBSP323R

THIS PAGE: Hope X2 Brake Pads
Sintered: HBSP237S
Organic: HBSP237

Replacing your brake pads for the first time? Or just want to refresh the best practices? Check out a pair of videos about installing new brake pads and the importance of removing the bleed port prior to service.

Want to more easily bleed and flush your Hope Brakes? Pickup the Hope Easy Brake Bleed Kit for Tech 3 Hope Brakes.

Do You Need To Replace Your Rotors As Well?

The nature of brake pad and rotor interface means they will wear together. Ideally you will be able to replace your brake pads a few times before you need to replace your rotors. however there can be some conditions that make it necessary to replace the rotors sooner. Let’s look at a few.

Rotor Wear:

The easiest thing to check is the rotor wear limit.

A Magura rotor that is less than 1.8mm wide is considered worn. SRAM rotors less than 1.5mm are worn. Shimano rotors less than 1.5mm or if any of the aluminum “Ice-Tech” material appears are considered worn.

Running too thin of a rotor will compromise brake bite as well as heat capacity. In extreme cases it can lead to rotor separation which will cause damage and potentially severe injury.

Rotor Shape:

If the previous pads have worn shapes into the rotor your performance will be compromised. Whether the rotor shows knife edge, bulge or convex anything but parallel surfaces will cause contact patch issues.

These issues will create extreme “hot-spots” on the new brake pads which, in some conditions, can super heat the pad – glazing it and compromising the friction coefficient (bite, power, heat capacity are all effected).

We have seen cases where new brake pads become unusable due to this severe heat modifying the pad’s makeup glazing not just the contact surfaces but essentially glazing the entire pad material.

A rule of thumb is rotors should be replaced about every three or four sets of pads. It will pay dividends to check the rotor’s condition before installing new pads!

Shop MTB Rotors Here

Return to Top of Page