Description
SRAM CODE Metallic Brake Pads
SRAM Disc Brake Pads – Sintered Compound, Steel Backed, Powerful, For SRAM Code (after 2011) and SRAM Guide RE, pad shape 36
Original equipment pads for no-compromise disc brake performance.
Steel backed sintered pad offers powerful braking
Each pad kit includes two pads, a pad spreader spring, pad pin and clip
Manufacturer Part Number: 00.5315.023.010
UPC: 710845642012
Pad Shape Number: 36
Backing Plate Material: Steel
Compound: Sintered
SRAM CODE Organic Brake Pads
Organic Compound, Steel Backed, Quiet, For Code (after 2011) and Guide RE, Pad Shape 36
Original equipment pads for no-compromise disc brake performance.
Steel backed organic pad is quiet
Each pad kit includes two pads, a pad spreader spring, pad pin and clip
Manufacturer Part Number: 00.5315.023.030
UPC: 710845642036
Pad Shape Number: 36
Backing Plate Material:Â Steel
Compound:Â Organic
SRAM CODE Organic Brake Pads Alum Backed
SRAM Disc Brake Pads – Organic Compound, Aluminum Backed, Quiet/Light, For Code (after 2011) and Guide RE, pad shape 36
Original equipment pads for no-compromise disc brake performance.
Aluminum backed organic pad is quiet and lightweight
Each pad kit includes two pads, a pad spreader spring, pad pin and clip
Manufacturer Part Number: 00.5315.023.020
UPC: 710845642029
Pad Shape Number: 36
Backing Plate Material: Aluminum
Compound:Â Organic
SRAM Brake Pads
Looking for other SRAM Brake Pads?
Pad Shape 01 – SRAM Level
Pad Shape 36- SRAM CODE & SRAM Guide RE (this page)
SRAM Code Brake Pads Only, no spring or clip available here
Pad Shape 58 – SRAM G2 and SRAM Guide
SRAM G2 Brake Pads Only, no spring, pad pin or clip – Sintered and Organic available here.
Replacing your brake pads for the first time? Or just want to refresh the best practices? Check out a pair of videos about installing new brake pads and the importance of removing the bleed port prior to service.
Do You Need To Replace Your Rotors As Well?
The nature of brake pad and rotor interface means they will wear together. Ideally you will be able to replace your brake pads a few times before you need to replace your rotors. however there can be some conditions that make it necessary to replace the rotors sooner. Let’s look at a few.
Rotor Wear:
The easiest thing to check is the rotor wear limit.
A Magura rotor that is less than 1.8mm wide is considered worn. SRAM rotors less than 1.5mm are worn. Shimano rotors less than 1.5mm or if any of the aluminum “Ice-Tech” material appears are considered worn.
Running too thin of a rotor will compromise brake bite as well as heat capacity. In extreme cases it can lead to rotor separation which will cause damage and potentially severe injury.
Rotor Shape:
If the previous pads have worn shapes into the rotor your performance will be compromised. Whether the rotor shows knife edge, bulge or convex anything but parallel surfaces will cause contact patch issues.
These issues will create extreme “hot-spots” on the new brake pads which, in some conditions, can super heat the pad – glazing it and compromising the friction coefficient (bite, power, heat capacity are all effected).
We have seen cases where new brake pads become unusable due to this severe heat modifying the pad’s makeup glazing not just the contact surfaces but essentially glazing the entire pad material.
A rule of thumb is rotors should be replaced about every three or four sets of pads. It will pay dividends to check the rotor’s condition before installing new pads!